Fits most 16×7 ft two-car doors. Banner size: 157.5 × 70.9 in (13 × 6 ft) with a clean border that avoids handles, door controls, and sensors. In the box: Banner with 7 grommets (5 top, 2 bottom) + rubber rings, hanging rope, double-sided stickers, stainless-steel clamps, small nails (for wood). Before you start Keep the garage door closed. Clean & dry the mounting area. Adhesion drops on dusty, wet, or very cold surfaces. Plan the position so the banner doesn’t cover the handle, door controls, or photo-eye sensors near the bottom of the door. Three easy ways to mount A. Rope to header/trim (stable & flat) Thread the rope through the 5 top grommets for even load. Tie to the door header/trim or another solid point. Tension lightly and knot; secure both bottom corners to keep the banner flat. B. Double-sided stickers (for alignment & edge-sealing) Place stickers on corners and along edges (every 16–24 in). Press firmly for 10+ seconds. On metal doors, use rope/clamps for load; stickers just help “line up & seal”. C. Clamps / small nails (for rails, fences, or wood) Use clamps on thin trim/rails; Use small nails only on wood (never nail into metal door panels); Set the top first, then add light tension on the bottom corners. Use & safety For a smooth appearance, display with the door closed. If you must open the door, make sure the banner does not touch hinges, tracks, or sensors, and secure the bottom corners. Bring indoors during strong wind or rain to extend life. To release folds: low-steam from the back, let cool, then rehang. Size tolerance: ±1 in (±2.5 cm). Color variation: Fabric prints can look brighter in direct sun and deeper in shade. Due to screen calibration, ambient lighting, and normal batch printing, slight color differences from photos may occur. View in natural daylight for the most accurate look—minor variation is normal and does not affect use or photos.