Material: wood Size: Folded Size: 52 × 28 × 8cm / 20.5 x 11 x 3.1inch Unfolded Size: 38 × 32 × 27cm / 15 x 12.6 x 10.6inch Accessories: screw × 2, anti-slid sticker × 4, string shuttle × 4, ball of string × 1 Installations and User Guide: 1. Unfold the looming machine as is shown in the diagram, insert the screws into the side holes and tighten to stabilize the machine. 2. Stick an anti-skid sticker to each bottom corner of the loom to prevent from sliding during use. 3. Turn the bottom axis to tighten the white warps and fix with the wood block. 4. Thread the string shuttle through the white warps. Make sure a certain length of string is left at the end. 5. Turn the top axis by about 270° to swap the positions of the upper and lower rows of white warps. 6. Thread the string shuttle through the white warps again. Please not to make a tight turn, so that the white warps stay parallel. 7. Use the red comb to move the string lines close to each other. 8. Reverse the top axis by about 270°, thread the string shuttle back through the white warps again, then use the red comb to move the string line close to the others. Repeat the steps above. Warning: Small gadgets are included. To avoid accidental swallowing, adult company is required when it is played by small children.